Недавнее содержимое от 12345

Well... Personally I like the ideia of an interpreted language in Wifi Soc modules when you don't need a super performance... It's easy to make new solutions without recompile everything... And you can storage your code in external memories like sd-card and etc...

Hi! I found this port of micropython wylinks/micropython-ameba it's based on sdk 4.0 it seems to works! I don't know if it's bug free but it seems a good start for a better port by PVVX?

@A_D @pvvx Nice work guys! To pvvx I don't understand this about 8710bn uart... On my 8710bn uart works fine. On the defective 8195 the rx pin from uart log was physicaly disconected from the IC by a manufacturer error :(

Hi! I had some developed firmware for 8710af series based on sdk3.5 from mp3 git repository. I have some questions related with Sdram usage. When I write the created binary to ram it seem to have strange behaviour: <RTL8195A> ===== Enter SRAM-Boot 1 ==== CPU CLK: 83333333 Hz, SOC FUNC EN...

@pvvx Yes I know about ld placement area... I will have to make a pause on BN series still no luck

Hi! I will tell you a bit about my experience with RTL modules ... Well I started adpting RTL-00 modules to node mcu esp 8266 boards. At the time I had done this there are no easy avaliable dev boards! They work great the only cons is the leds inside the module. My second attempt was with...

@pvvx this last firmware (MICO ) have a wrong signature if I use the default bootloader that cames with my module:( (also editing the img to jump to the correct adress) I'am writting OTA2 img to 0x08080000 and I edited OTA2 img adress to 20 00 08 08 but it still hard fault :( Do you have a...

@pvvx HI! Thanks for the rtltool.py! Now I can read / write erase my W25Q64. My only problem now is to load a new application on OTA2 partition. I edited system partition (0x9000) for it load from OTA2 and corrected the flash parameters. I compile the demo that comes with sdk4.0 on...

I have two problems. 1) I use linux. 2)SDK tools (based on Jlink scripts) seens to support only support 1MB :( and SDK 4.0 can't make a full image (RTL8710BN have a different flash layout than RTL8710A it includes SystemData section and others ) And it's bad that SDK4.0 boot.bin is only 4KB. I...

H! Anybody had a sucess in re-flash this module with another flash other than the 2MB that comes with the module? Because it seems that with the tools that come with sdk4.0 only works with 1MB flash ic. Because I can only write flash one time after that it hangs with W25Q64FV. Does it need to...

I like rtl chips it's better than esp "xx" in general but this BN series are very limited in I / O and should have a bit more. BN series is nice for arduboys to make shields and connect it to 5V atmegas and use AT command interface not more than this,